ISO INTERNATIONAL STANDARD 3078 Third edition 2016-11-15 Shipbuilding Cargo winches Construction navale - Treuils de charge Reference number ISO 3078:2016(E) ISO Intemational Organization for Standardization IS02016 No reproduction or itted without license from IHS IS0 3078:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS02016,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 copyright@iso.org www.iso.org Intemationaibr PrganizationforStandardization networking permited without license from IHS IS03078:2016(E) Contents Page Foreword ..iv 1 Scope. 2 Normative references 3 Termsanddefinitions 4 Design and operation .3 4.1 General .3 4.2 Stress calculation 4.3 Directionofmotionofoperatingcontroldevice. .3 4.4 Accelerationanddeceleration .4 4.5 Braking. 4 4.6 Drum design .4 4.7 Warping ends 4 5 Performance. .5 6 Acceptancetests. .5 6.1 Rules concerning acceptance tests at manufacturer's works by purchaser .5 6.1.1 General. .5 6.1.2 Type testing .5 6.1.3 Individual test .6 6.2 On-boardacceptancetests. .6 7 Designation .6 8 Marking. ..7 Bibliography. .8 Inteainal oganzation @stS.20.1.6 - All rights reserved iii vithoutlicense from IHS