ISO INTERNATIONAL STANDARD 3529-3 Secondedition 2014-04-15 Vacuum technology Vocabulary - Part 3: Total and partial pressure vacuum gauges Technique du vide - Vocabulaire - Partie 3: Manometres de pression totale et analyseurs de pressions partielles Reference number IS03529-3:2014(E) LSO IS02014 HS under ed without license from IHS Not for Resale IS0 3529-3:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 3529-3:2014(E) Contents Page Foreword ..iv 1 Scope ..1 2 Terms and definitions 2.1 General terms. 1 2.2 General categories of vacuum gauges 2.3 Characteristics of vacuum gauges .2 2.4 Total pressure vacuum gauges .3 2.5 Partial pressure vacuum gauges .7 Annex A (informative) Tree diagram of total pressure vacuum gauges .9 Bibliography .10 ii ded by IHS under lic ense with ISt ted without license from IHS Not for Resale