ISO INTERNATIONAL STANDARD 464 Third edition 2015-11-01 Rolling bearings Radial bearings with locating snap ring Dimensions, geometrical product specifications (GPS) and tolerance values Roulements-Roulements radiaux a segment d'arret-Dimensions, speécification geéométrique des produits (GPS) et valeurs de tolérance Reference number IS0 464:2015(E) SO International Organization for Standardization @ IS0 2015 vided by IHS under ted without license from IHS IS0 464:2015(E) COPYRIGHTPROTECTEDDOCUMENT IS02015,PublishedinSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel.+41 22 749 01 11 Fax+412274909 47 copyright@iso.org www.iso.org Intenationai br Prganization for Standardization icensee-ZHEJIANG INST OF STANDARDIzAoISQ s.5 -All rights reserved vided by IHS unde etworking permitted without license from IHS IS0 464:2015(E) Contents Page Foreword .iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions 4 Symbols. .1 5 Snap ring groove and chamfer dimensions and tolerance values ..4 6 Snap ring dimensions and tolerance values 1 Annex A (informative) Snap ring groove and chamfer dimensions and tolerance values for radial bearings, D < 30 mm. .10 Annex B (informative) Snap rings for radial bearings, D < 30 mm ..11 Annex C (informative) Material of snap ring ..12 Annex D (informative) Application example ..13 Annex E (informative) Example of drawing indications of characteristics with specification for a snap ring groove. .14 Bibliography .15 iii ZHEJIANG INSTOFSTANDARDIZATIONC15956617 ut license from IHS