ISO INTERNATIONAL STANDARD 4951-3 First edition 2001-02-15 High yield strength steel bars and sections - Part 3: Delivery conditions for thermomechanically-rolled steels Barres et profiles en acier a haute limite d'élasticité - Partie 3: Conditions de livraison des aciers obtenus par laminage thermomecanique Reference number ISO 4951-3:2001(E) ISO @ ISO 2001 ISO 4951-3:2001(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii @ IsO 2001 - All rights reserved ISO4951-3:2001(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through ISsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of isO 4951 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 4951-3 was prepared by Technical Committee ISO/TC 17, Steel, Subcommittee SC 3, Steels for structural purposes. This first edition of ISO 4951-3, together with ISO 4951-1 and ISO 4951-2, cancels and replaces ISO 4951:1979 the content of which has been revised and augmented. IsO 4951 consists of the following parts, under the general title High yield strength steel bars and sections: Part 1: General delivery requirements Part 2: Delivery conditions for normalized, normalized rolled and as-rolled steels -Part3:Deliveryconditionsforthermomechanically-rolledsteels @ ISO 2001 - All rights reserved ii