ISO INTERNATIONAL STANDARD 5468 Fourth edition 2017-02 Rotary and rotary impact masonry drill bits with hardmetal tips Dimensions Forets pour batiment, a rotation et percussion, a plaquettes en métal- dur (carbures métalliques) Dimensions Reference number ISO 5468:2017(E) so International Organization for Standardization e=ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02017 vided by IHS under I No reproduction or networking permitted without license from IHS IS0 5468:2017(E) COPYRIGHTPROTECTED DOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either Iso at the address below or Iso's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinir DrganizationforStandardization Licensee-ZHEJIANG INST OF STANDARDIZoISQ37 -All rights reserved Not for Resale, 2017/5/11 02:39:10 No reproduction or networking permited without license from IHS IS0 5468:2017(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope.. 2 Normative references 3 Terms and definitions ..1 4 Dimensions ..1 Annex A (informative) Relationship between designations in this document and IS0 13399 series 3 Bibliography. 4 ntemaonalgnzatin7-All rights reserved iii nSee=ZHEJIANG INST OF STANDARDIZATION C15956617 ed without license from IHS