ISO INTERNATIONAL STANDARD 5610-4 Secondedition 2014-09-01 Tool holders with rectangular shank for indexable inserts - Part 4: Style D Porte-plaquette a queue rectangulaire pour plaquettes amovibles Partie 4: Forme D Reference number IS0 5610-4:2014(E) ISO CopyrightintemationalOrganizationfor Standardization @IS02014 Not for Resale IS0 5610-4:2014(E) COPYRIGHT PROTECTED DOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS0 5610-4:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references ..1 3 Dimensions. 3.1 General .1 3.2 Tool holder style D for square indexable insert shape S 3.3 Tool holder style D for round indexable insert shape R 4 4 Designation .6 5 Material. ..7 6 Design .1 6.1 Type of mounting. 6.2 Corner radius, r 6.3 Thickness, s, of indexable insert 7 Extent of delivery 8 Marking. Bibliography 9 Copyritnteatinal rganiason t? Sanadizah rights reserved iii ded by IHS under lic se with ISt ed without license from IHS Not for Resale