ISO INTERNATIONAL STANDARD 6262-2 Secondedition 2013-09-01 End mills with indexable inserts - Part 2: End mills with Morse taper shank Fraises en bout a plaquettes amovibles - Partie 2: Fraises a queue cone Morse Reference number IS0 6262-2:2013(E) LSO @IS02013 IHS under I ted without license from IHS Not for Resale IS0 6262-2:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 6262-2:2013(E) Contents Page Foreword ..iv 1 Scope .1 2 Normativereferences 3 Dimensions Annex A (informative) Relationship between designations in this part of Is0 6262 and the Is0 13399 series. .3 Bibliography .4 iii d by IHS under lic se with ISt ted withoutlicensefromIHS Not for Resale