ISO INTERNATIONAL STANDARD 6279 Third edition 2017-03 Plain bearings Aluminium alloys for solid bearings Paliers lisses - Alliages d'aluminium pour paliers massifs Reference number ISO 6279:2017(E) so International Organization for Standardization see=ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02017 vided by IHS under I No reproduction or networking permitted without license from IHS IS0 6279:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 · CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internationai ibrg DrganizationforStandardization Licensee-ZHEJIANG INST OF STANDARDIZAISQ 017 - All rights reserved Not for Resale, 2017/5/11 02:06:11 networking permited withoutlicense from IHS IS0 6279:2017(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Composition and mechanical properties 4.1 Composition. ..1 4.2 Mechanical properties 5 Test methods. .1 6 Designation 2 Intemaional oganzation @stS2017 - All rights reserved ii icensee-ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under I se with ISt ted without license from IHS