ISO INTERNATIONAL STANDARD 6361-4 Third edition 2014-09-15 Wrought aluminium and aluminium alloys Sheets, strips and plates Part 4: Sheets and plates: Tolerances on shape and dimensions Aluminium et alliages d'aluminium corroyés - Toles, bandes et toles épaisses Partie 4: Toles et toles épaisses: Tolerances sur forme et dimensions Reference number IS0 6361-4:2014(E) ISO Copyright International Organization for Standardization @ IS0 2014 ed without license from IHS Not for Resale IS0 6361-4:2014(E) COPYRIGHT PROTECTED DOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS0 6361-4:2014(E) Contents Page Foreword ..iv 1 Scope ..1 2 Normative references 3 Dimensional tolerances 3.1 Thickness. 3.2 Width. 3.3 Length. .6 4 Shape tolerances. .7 4.1 Lateral curvature. 4.2 Flatness tolerances. 4.3 Squareness tolerances 10 Bibliography .12 ii ded by IHS under lic se with ISt ted without licensefrom IHS Not for Resale