ISO INTERNATIONAL STANDARD 6482 Second edition 2017-05 Shipbuilding Deck machinery - Warping end profiles Construction navale - Auxiliaires de pont - Profils de poupée Reference number IS0 6482:2017(E) [so International Organization for Standardization @ IS0 2017 =ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under I Not for Resale, 2017/8/21 01:44:20 itted without license from IHS IS0 6482:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 copyright@iso.org www.iso.org Prganization for Standardization icensee-ZHEJIANG INSTOF STANDARDIZAoISQ07 -All rights reserved Not for Resale, 2017/8/21 01:44:20 etworking permitted without license from IHS IS0 6482:2017(E) Contents Page Foreword ..iv 1 Scope 1 2 Normative references ..1 3 Terms and definitions ..1 4 Types, nominal sizes and dimensions 4.1 Types... .1 4.2 Nominal sizes and dimensions. 5 Relation between warping end dimensions and rope sizes 3 5.1 Proportional relation between warping end lengths and selected rope sizes. .3 5.2 Proportional relation between warping end diameters and selected rope sizes 6 Calculation of warping end shaft torque and bending moment 6.1 Calculated position of maximum torque.. .3 6.2 Calculated position of bending moment at maximum torque .3 7 Dimensional tolerances and surface roughness .4 8 Designation 4 iii e=ZHEJIANG INST OF STANDARDIZATION C15956617 vided by IHS underI thout license from IHS