ISO/IEC INTERNATIONAL STANDARD 24727-1 Secondedition 2014-06-15 Identification cards Integrated circuit card programming interfaces Part 1: Architecture Cartes d'identification - Interfaces programmables de cartes a puce- Partie 1: Architecture Reference number IS0/IEC24727-1:2014(E) . @IS0/IEC2014 No repr ted without license from IHS Not for Resale IS0/IEC 24727-1:2014(E) COPYRIGHTPROTECTEDDOCUMENT @IS0/IEC2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +4122 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0/IEC 2014 -All rights reserved No reproductic networking permtted without license from IHS Not for Resale IS0/IEC 24727-1:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms and definitions 4 Abbreviated terms 3 5 Interoperability ..3 6 Architecture ..4 6.1 General ..4 6.2 Architectural attributes ..4 6.3 Logical architecture. .4 6.4 Protocol independence 6.5 Client-application service access layer interface. 6 6.6 Capability description ..6 6.7 Data model .6 6.8 Generic card interface 6.9 Connectivity interface 1 6.10 Trusted channel interface 1 7 Security rationale .7 AnnexA(informative)Implementationconfigurationexamples .8 Bibliography .18 iii ense with ISt without license from IHS Not for Resale