INTERNATIONAL ISO/IEC STANDARD 24769-61 First edition 2015-10-01 Information Technology Real Time Locating System (RTLS) Device Conformance Test Methods Part 61: Low rate pulse repetition frequency Ultra Wide Band (UWB) air interface Technologies de I'information - Methodes d'essai de conformité du dispositif des systemes de localisation en temps réel (RTLS) Partie 61: Interface d'air ultra large a bas taux de bande de frequence de répétition d'impulsion (UWB) Reference number IS0/IEC 24769-61:2015(E) TEC ISO @IS0/IEC 2015 IS0/IEC 24769-61:2015(E) COPYRIGHT PROTECTED DOCUMENT IS0/IEC 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form writtenpermission.Permission canberequestedfromeitherIsOattheaddressbelow orIso'smemberbodyinthecountryof the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org ii @ IS0/IEC 2015 - All rights reserved IS0/IEC 24769-61:2015(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms, definitions and abbreviated terms. ..1 3.1 Terms and definitions .1 3.2 Abbreviated terms.. 4 Conformance tests forIS0/IEC 24730-61 .2 4.1 General. 2 4.2 Default conditions applicable to the test methods .2 4.2.1 Test environment 2 4.2.2 Default tolerance. .2 4.2.3 Noise floor at test location 2 4.2.4 Total measurement uncertainty .3 4.3 Tag UWB RF transmission tests 3 4.3.1 General 3 4.3.2 Test Objective 3 4.3.3 Test procedure 3 4.3.4 Test measurements and requirements .4 4.3.5 Test report 4 4.4 Receiver UWB RF tests .4 4.4.1 General. 4 4.4.2 Test objective .5 4.4.3 Test procedure .5 4.4.4 Test measurements and requirements 5 4.4.5 Test report. .5 Annex A (normative) RF test measurement site .6 @ IS0/IEC 2015 - All rights reserved iii