ISO INTERNATIONAL STANDARD 11148-2 First edition 2011-12-01 Hand-held non-electric power tools - Safety requirements - Part 2: Cutting-off and crimping power tools Machines portatives a moteur non électrique Exigences de sécurite- Partie 2: Machines de deécoupe et de sertissage Reference number ISO 11148-2:2011(E) @ ISO 2011 py IHS under ted without license from IHS Not for Resale ISO 11148-2:2011(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's memberbody in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2011 - All rights reserved tworking permited without license from IHS Not for Resale ISO 11148-2:2011(E) Contents Page Foreword Introduction 1 Scope 2 Normative references. 3 Terms and definitions . 3.1 General terms and definitions.. 3.2 Terms and definitions related to cutting-off and crimping power tools 4 Safety requirements and/or protective measures. 4.1 General. 4.2 Mechanical safety.. 4.3 Thermal safety .... 4.4 Noisereduction 4.5 Vibration... 4.6 Materials and substances processed, used or exhausted. 4.7 Ergonomics 4.8 Controls. 5 Verification .... 5.1 General conditions for tests.. 5.2 Noise... 5.3 Vibration 5.4 Unintentional start... 5.5 Powertoolconstruction 5.6 Structure of verification of safety requirements 6 Informationforuse. 6.1 Marking, signs and written warnings . 6.2 Instructionhandbook... 10 6.3 Operating instructions.. 6.4 15 6.5 Maintenance instructions Annex A (informative) List of significant hazards .... Annex B (informative) Examples of power tools covered by this part of Iso 11148 Annex C (normative) Symbols for labels and signs.. Bibliography..... Copyright International Organization for Standardizallon'ghts reserved ili nse from IHS Not for Resale