ISO INTERNATIONAL STANDARD 11170 Third edition 2013-02-15 Hydraulic fluid power Sequence of tests for verifying performance characteristics of filter elements Transmissions hydrauliques - Ordre des essais pour la verification des caractéristiques de performance des élements filtrants Reference number IS0 11170:2013(E) @ IS0 2013 lational Orqanization for Standardization HS unde =Universitv of Alberta/5966844001, User=sharabiani, shahramfs No reproduction or networking permitted without license from IHS IS0 11170:2013(E) COPYRIGHT PROTECTED DOCUMENT IS02013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax+41227490947 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved national Organizationfor Standardization ided bv IHS under lic with ISC Licensee=UniversitofAberta/5966844001, User=sharabiani, shahramfs No reproduction or networking permitted without license from IHS Not for Resale, 11/30/2013 23:02:33 MST IS0 11170:2013(E) Contents Page Foreword iv Introduction. 1 Scope. 2 Normative references. 3 Terms and definitions. 4 Test elements. 5 Test procedure. N 5.1 General .... 5.2 Fabrication integrity test. 5.3 Material compatibility test 5.4 Other tests. 6 Test report. 5 7 Identification statement (reference to this International Standard) 5 arightsreserved iii Licensee=Universitv of Alberta/5966844001, User=sharabiani, shahramfs No reproduction or networking permited without license from IHS Not for Resale, 11/30/2013 23:02:33 MST