ISO INTERNATIONAL STANDARD 11431 Second edition 2002-08-15 Building construction Jointing products Determination of adhesion/cohesion properties of sealants after exposure to heat, water and artificial light through glass Construction immobiliere- Produits pour joints - Détermination des proprietés d'adhésivité/cohésion des mastics apres exposition a la chaleur, a l'eau et ala lumiereartificielle atravers le verre Reference number ISO 11431:2002(E) @ ISO 2002 Copyright International Organizatin for Standardization No reproduction or networking permited without license from IHS Not for Resale ISO11431:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland yatigaaiSandardizato @ ISO 2002 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 11431:2002(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. patent rights. IsO shall not be held responsible for identifying any or all such patent rights. Subcommittee SC 8, Jointing products. This second edition cancels and replaces the first edition (IsO 11431:1993), which has been technically revised CopyrightIntenational Organizationfor Standadizationserved ili Not for Resale