ISO INTERNATIONAL STANDARD 16145-2 First edition 2012-10-01 Ships and marine technology Protective coatings and inspection method - Part 2: Void spaces of bulk carriers and oil tankers Navires et technologie maritime Revetements de protection et methoded'inspection Partie 2: Espaces vides de vraquiers et de réservoirs d'huile Reference number ISO 16145-2:2012(E) ISO Copyright intematioal Organizatin for Standardizatin @ISO2012 No reproo Not for Resale ISO 16145-2:2012(E) COPYRiGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2012 - All rights reserved No reproduction or networking permtted without license from IHS Not for Resale ISO 16145-2:2012(E) Contents Page Foreword ..iv Introduction 1 Scope. 2 Normative references 3 Terms and definitions. .2 4 Symbols and abbreviated terms 3 4.1 Symbols.... 3 4.2 Abbreviated terms.. 3 5 General procedures for coating work. 3 6 Standard for coating work 6.1 Areas considered. 4 6.2 Surface preparation .. 6 6.3 Primary surface preparation and shop priming. 8 6.4 Secondary surface preparation. 9 6.5 Coating 10 6.6 Treatment for coating defects 13 L Inspection 14 7.1 Inspection procedure 14 7.2 Coating inspection.. 14 7.3 Dry film thickness measurement Annex A (informative) Measurement of the conductivity for abrasives. .21 AnnexB(informative)Measurementofwatersolublesalt... .23 Annex C (informative) Inspection items and management of inspection .25 Annex D (informative) Standard for coating technical file (CTF). .29 Bibliography .38 ili lout license from IHS Not for Resale