DRAFT INTERNATIONAL STANDARD ISO/DIS 16160 'So ISO/TC 17/SC 12 Secretariat: ANSI Voting begins on Voting terminates on 2012-02-07 2012-07-07 MEKYHAPOAHAOPTAHV3ALMOCTAHAPTV3ALMM ORGANISATION INTERNATIONALE DE NORMALISATION Hot-rolled steel sheet products Dimensional and shape tolerances Toles en acier laminées a chaud - Tolérances sur dimensions et forme [Revision of third edition (ISO 16160:2011)] ICS 77.140.50 InaccordancewiththeprovisionsofCouncilResolution15/1993thisdocumentiscirculatedin the English language only. Conformément aux dispositions de la Résolution du Conseil 15/1993, ce document est distribue en version anglaise seulement. To expedite distribution, this document is circulated as received from the committee secretariat.isOCentral Secretariatworkofediting andtextcompositionwillbeundertakenat publication stage. Pour accelerer la distribution, le présent document est distribué tel qu'il est parvenu du secretariat du comite. Le travail de redaction et de composition de texte sera effectué au Secretariat central de I'isO au stade de publication. REFERRED TO AS AN INTERNATIONAL STANDARD UNTIL PUBLISHED AS SUCH. IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECHNOLOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT WHICH REFERENCE MAY BE MADE IN NATIONAL REGULATIONS. THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION. Copyright International Organization for Standardization Organization for Standardization, 212 ed without license from IHS Not for Resale ISO/DIS 16160 Copyright notice This IsO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, photocopying, recording or otherwise, without prior written permission being secured. Requests for permission to reproduce should be addressed to either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Reproduction may be subject to royalty payments or a licensing agreement. Violators may be prosecuted. @ ISO 2012 -All rights reserved vided by IHS under I without license from IHS Not for Resale DRAFTINTERNATIONALSTANDARD Revision To ISO 16160:2011 TC17/SC12 January 16, 2012 Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out throughIsO technical committees.Each memberbody interestedin a subject for whicha technica committeehas been established has theright toberepresentedon that committee.International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. InternationalStandardsaredraftedinaccordancewiththerulesgivenintheISO/lECDirectives,Part2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. sO shall not be held responsible for identifying any or all such patent rights. ISO 16160 was prepared by Technical Committee ISO/TC 17, Steel, Subcommittee SC 12, ContinuouS mill flat rolled products. This fourth edition cancels and replaces the third edition (iSO 16160:2011), which has been technically revised. onal Organizat