INTERNATIONAL STANDARDISO 9606-1:2012 ISO TECHNICAL CORRIGENDUM 1 INTERNATIONA NORMALISATION Qualification testing of welders Fusion welding Part 1: Steels TECHNICAL CORRIGENDUM 1 Epreuve de qualification des soudeurs - Soudage par fusion - Partie 1: Partie 1: Aciers RECTIFICATIFTECHNIQUE1 allied processes, Subcommittee sc 11, Qualification requirements for welding and allied processes personnel. Page 19,6.5.1 Delete the final sentence so that the subclause reads as follows. 6.5.1 General In 6.5.2 and 6.5.3, details of the type, dimensions, and preparation of the test pieces and test specimens are given. In addition, the requirements for destructive tests are indicated. For root, face or side bend, or fracture tests, one specimen shall be taken from the start and stop area in the examination length. ICS 25.160.01 Ref. No.ISO 9606-1:2012/Cor.1:2012(E) ISO2012-All rightsreserved Published in Switzerland ISO INTERNATIONAL STANDARD 9606-1 Second edition 2012-07-15 Qualification testing of welders Fusion welding Part 1: Steels Epreuve de qualification des soudeurs - Soudage par fusion Partie 1: Aciers Reference number ISO 9606-1:2012(E) @ ISO 2012 ISO 9606-1:2012(E) COPYRIGHTPROTECTEDDOCUMENT ?ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or isO's memberbody inthe country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland = @ISO 2012-All rights reserved