ISOIASTM INTERNATIONAL STANDARD 51702 Third edition 2013-04-15 Practice for dosimetry in a gamma facility for radiation processing Practique pour la dosimetrie dans les installations pour I'irradiation gamma Reference number ISO/ASTM 51702:2013(E) INTERNATIONAL ISO/ASTMInternational2013 Copyright Intermational Organization for Standardization Not for Resale ISO/ASTM51702:2013(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, thisfile may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this _file parties accept therein the.responsibility of not infringing Adobe's licensing policy. Neither the ISO Central Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file:the PDF-creation International at the addresses given below. ISO/ASTMInternational2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical. including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. In the United States, such requests should be sent to ASTM International. ISO copyright ofice ASTM International, 100 Barr Harbor Drive, PO Box C700 Case postale 56·CH-1211Geneva 20 West Conshohocken, PA 19428-2959, USA Tel. +41 22 749 01 11 Tel. +610 832 9634 Fax +41 22 749 09 47 Fax +610 832 9635 E-mail [email protected] E-mail [email protected] Web www.iso.org Web www.astm.org Published in the United States ii ISO/ASTM International 2013 - All rights reserved CopyrightintematinalOrganizatinforStandardizatin Nroductioneworkingpmitedwithut iceefm Not for Resale ISO/ASTM51702:2013(E) Contents Page 1 Scope 1 2 Referenced documents 1 3Terminology 1 4 Significance and use 2 5 Radiation source characteristics 3 6 Types offacilities 3 7 Dosimetry system calibration 3 8 Installation qualification 3 9 Operational qualification 4 10 Performance qualification 5 11 Routine product processing 7 12Certification 7 13 Measurement uncertainty 8 14 Keywords 8 Bibliography 8 @ISO/ASTM International 2013-All rights reserved ili Copyright Intermational Organization for Standardization Not for Resale