TECHNICAL ISO/TR REPORT 16377 First edition 2012-07-15 Further clarification of ISO 28580 Précisions concernant I'lSO28580 Reference number ISO/TR 16377:2012(E) ISO @ISO2012 ISO/TR 16377:2012(E) COPYRIGHTPROTECTEDDOCUMENT ISO 2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland = @ ISO 2012 -All rights reserved ISO/TR 16377:2012(E) Contents Page Foreword .iv Introduction 1 Scope. 2 General. 3 Clause 3, Terms and definitions. 3.1 Additional definition: candidate machine 3.2 Definition 3.13: deviation of alignment tyre 4 Clause 6, Test conditions.. 4.1 Subclause 6.2, Table 1, and subclause 6.4, Table 2 4.2 Subclause 6.4, Table 2.. 5 Clause 7, Test procedure 5.1 Subclause 7.4, Table 3.. 5.2 Subclause 7.6.2, Note 1 2 5.3 Subclause 7.6.3, list item a) 2 6 Subclause 8.1, Determination of parasitic loss. 2 7 Subclause 10.2, Conditions for reference machine, and subclause 10.3, Conditions for candidate machine...... 3 @ ISO 2012 -All rights reserved ili