ISO/TR TECHNICAL REPORT 4378-6 First edition 2012-02-01 Plain bearings Terms, definitions, classification and symbols - Part 6: Abbreviated terms Paliers lisses Termes, définitions, classification et symboles- Partie 6: Termes abregés Reference number ISO/TR 4378-6:2012(E) ISO @ISO2012 I by IHS under lic No reproduction or networking permitted without license from IHS Not for Resale ISO/TR 4378-6:2012(E) COPYRiGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2012 - All rights reserved or networking permitted without license from IHS Not for Resale ISO/TR 4378-6:2012(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental,inliaisonwithlsO,alsotakepartinthework.IsOcollaboratescloselywiththeInternational Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. In exceptional circumstances, when a technical committee has collected data of a different kind from that which is normally published as an International Standard ("state of the art", for example), it may decide by a simple majority vote of its participating members to publish a Technical Report. A Technical Report is entirely informative in nature and does not have to be reviewed until the data it provides are considered to be no longer validoruseful. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO/TR 4378-6 was prepared by Technical Committee ISO/TC 123, Plain bearings, Subcommittee SC 6, Termsandcommonitems IsO 4378 consists of the following parts, under the general title Plain bearings - Terms, definitions, classification and symbols: Part 1: Design, bearing materials and their properties Part 2: Friction and wear Part 3: Lubrication Part 4: Basic symbols Part 5: Application of symbols Part 6: Abbreviated terms [Technical Report] ili