ISO INTERNATIONAL STANDARD 17491-3 First edition 2008-08-15 Protective clothing Test methods for clothing providing protection against chemicals - Part 3: Determination of resistance to penetration by a jet of liquid (jet test) Vetements de protection - Methodes d'essai pour les vetements fournissant une protection contre les produits chimiques- liquide (essai au jet) Reference number ISO 17491-3:2008(E) @ ISO 2008 national Organization for Standardization Not for Resale ISO 17491-3:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2008 - All rights reserved I without license from IHS Not for Resale ISO 17491-3:2008(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeer non-governmental, in liaison with isO, also take part in the work. Iso collaborates closely with the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. isO shall not be held responsible for identifying any or all such patent rights. ISO 17491-3 was prepared by the European Committee for Standardization (CEN) Technical Committee Technical Committee IsO/TC 94, Personal safety-Protective clothing and equipment, Subcommittee SC 13, (Vienna Agreement), This first edition of IsO 17491-3, together with IsO 17491-4, cancels and replaces IsO 17491:2002, Clauses 6 and 7 of which have been technically revised. IsO 17491 consists of the following parts, under the general title Protective clothing - Test methods for clothingprovidingprotectionagainst chemicals: The following parts are under development: Part 1: Determination of resistance to outward leakage of gases (internal pressure test) Part 2: Determination of resistance to inward leakage of aerosols and gases (inward leakage test) inal Oorganization for standardizalion'ghts reserved ii