ISO INTERNATIONAL STANDARD 17824 First edition 2009-08-15 Petroleum and natural gas industries - Downhole eguipment Sand screens Industries du peétrole et du gaz naturel - Equipement de fond de puits - Tamis de controle de sable Reference number ISO 17824:2009(E) @ ISO 2009 ISO 17824:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF fle can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT @ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland ii @ ISO 2009 - All rights reserved ISO 17824:2009(E) Contents Page Foreword. Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Abbreviated terms . 5 Functional specification.. 5.1 General 5.2 Product type. 5.3 Sandscreenparameters. 5.4 Wellparameters. 5.5 Operational parameters 5.6 Environmental compatibility.. 5.7 Compatibility with related well equipment. 5.8 Design validation grades ... 5.9 Quality grades.. 5.10 Specialqualityrequirements 6 Technical specification 6.1 General 6.2 Technicalcharacteristics 6.3 Design criteria. 6.4 Design verification 6.5 Design validation. 10 6.6 Design changes . 0 6.7 Design validation by scaling L Supplier/manufacturer requirements. 13 7.1 General. 13 7.2 Documentation and data control 13 7.3 Product identification ... 14 7.4 Quality control.... 14 8 Storage and transport 23 8.1 Storage... 23 8.2 Product protection.. 23 8.3 Transport... 23 Annex A (normative) Collapse pressure test . .24 Annex B (normative) Burst pressure test.. .27 Annex C (informative) Sized-bead test method.. 30 Annex D (informative) Sand control screen illustrations ... .32 Annex E (informative) Wire-wrap screen illustrations.. 34 Annex F (informative) Pre-pack screen illustrations . 35 Annex G (informative) Metal-mesh screen illustrations, 36 Annex H (informative) Increased wire-wrap slot size inspection .. 37 Bibliography 38 @Iso 2009 -All rights reserved ili