ISO INTERNATIONAL STANDARD 1926 Fourth edition 2009-12-01 Rigid cellular plastics Determination of tensile properties Plastiques alveolaires rigides Determination des caracteristiques en traction Reference number ISO 1926:2009(E) @ ISO 2009 ISO 1926:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF fle can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @ ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, isO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland ii @ ISO 2009 - All rights reserved ISO 1926:2009(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with isO, also take part in the work. isO collaborates closely /withthe International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote rights.IsO shallnotbeheldresponsiblefor identifyinganyorall suchpatent rights. ISO 1926 was prepared by Technical Committee ISO/TC 61, Plastics, Subcommittee SC 10, Cellular plastics @ Iso 2009 - All rights reserved ii