ISO/IEC INTERNATIONAL STANDARD 24751-3 First edition 2008-10-01 Information technology Individualized adaptability and accessibility in e-learning, education and training Part 3: "Access for all" digital resource description Technologies de Il'information-Adaptabilite et accessibilite individualisées en e-apprentissage, en éducation et en formation - Partie 3: Description des ressources numériques relatives a <acces pourtous Reference number ISO/IEC 24751-3:2008(E) ISO IEC @ ISO/IEC 2008 IHS unde Not for Resale ISO/IEC 24751-3:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHT PROTECTED DOCUMENT ISO/IEC2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland ISO/IEC 2008-All rights reserved I without license from IHS Not for Resale ISO/IEC24751-3:2008(E) Contents Page Foreword .iv Introduction. 1 Scope. 2 Normative references. 3 Termsanddefinitions 4 Symbolsandabbreviations.... 5 Basic Principles. .6 5.1 Assumptions.. 5.2 Original and Adapted Resources 5.3 Access For All Resource Metadata ... 5.4 AccessMode... 5.5 Adaptability ... 5.6 The Importance of Interoperability and Consistent Implementation 9 6 Access For All Digital Resource Description (DRD) Information Model ... 10 6.1 Access For All Digital Resource Description .. 10 6.2 Access Mode Statement ......... 10 6.3 Is Adaptation ... 6.4 Adaptation Statement . 11 7 Attribute Descriptions and Recommended Use 11 8 Extending the Standard. 15 9 Conformance .15 Annex A (normative) Consolidated List of Terms and Definitions with Cultural Adaptability: Iso French Equivalents .... ..16 A.1 Introduction... A.2 Iso English and Iso French... 16 A.3 Cultural adaptability and quality control... ...16 A.4 List of Terms in French Alphabetical Order A.5 Organization of Annex A.6, “Consolidated matrix of terms and definitions . Iso French equivalents" A.6 ConsolidatedMatrixofISO/IEC24751-3TermsandDefinitionsinISOFrench.. .19 Annex B (normative) Vocabulary Codes ... 23 B.1 Access Mode Usage Vocabulary Codes .. 23 B.2 Display Transformability Vocabulary Codes. 23 B.3 Extent Vocabulary Codes ..... 25 Annex C (informative) Recommended Default Values .. 26 Annex D (informative) Bindings and Implementations .. 27 Annex E (informative) Scenarios..... E.1 Scenario 1: Discovery and Retrieval of Alternate Training Content... E.2 Scenario 2: Customization of Information about a Prescription.. .28 E.3 Scenario 3: Extreme Instructional Environments.... 28 E.4 Scenario . Creating a Repository for Federated Searching ......... Annex F (informative) Implementation Example.. 30 F.1 TILE Low Vision Example.... 30 F.2 TILE Caption Example.. .33 Annex G (informative) List of contributors... Bibliography 38 ili nse from IHS Not for Resale