ISO INTERNATIONAL STANDARD 105-F06 First edition 2000-02-15 Textiles Tests for colour fastness Part F06: Specification for silk adjacent fabric Textiles - Essais de solidite des teintures - Partie Fo6: Spécification pour le tissu témoin en soie Reference number ISO 105-F06:2000(E) ISO @ ISO 2000 ISO 105-F06:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ? ISO 2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 4122 73410 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland ii @ISO2000-All rightsreserved ISO 105-F06:2000(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies(iso member bodies). The work of preparing International Standards is normally carried out through IsO technical liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3 Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of isO 105 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 105-F06 was prepared by Technical Committee ISO/TC 38, Textiles, Subcommittee Sc 1, Tests for coloured textiles and colorants. dates between 1978 and 1985. Each part contained a series of “sections", each designated by the respective part letter and by a two-digit serial number (e.g. "Section Ao1"). These sections are now being republished as separate these parts is given in ISO 105-A01. @IsO2000-All rightsreserved ili