ISO INTERNATIONAL STANDARD 13486-1 First edition 1999-10-01 Road vehicles Hydraulic braking systems - Part 1: Double-flare pipes, tapped holes, male fittings and tube seats Véhicules routiers Dispositifs de freinage hydraulique - Partie 1: Tuyauteries a double renflement, logements, raccords males et siege-guides rapportés ISO Reference number ISO 13486-1:1999(E) HS under ted without license from IHS Not for Resale ISO 13486-1:1999(E) Contents Page 1 Scope 2 Normative references 3Pipes 3.1 Pipe without flares.. 3.2 Double-flare pipes. 3.3 Material requirements. 3.4 Condition ... 4 Type A male fittings and type AS tapped holes.. 4.1 Type A male fittings 4.2 Type AS tapped holes 5 Type B male fittings and type BS tapped holes. 5.1 Type B male fittings. 5.2 Type BS tapped holes 6 6 Tube seats 7 Marking 8 ldentification statement 10 Bibliography @ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic International Organization for Standardization Case postale 56 · CH-1211 Geneve 20 · Switzerland Internet [email protected] Printed in Switzerland Not for Resale @ISO ISO 13486-1:1999(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through isO technical liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. International Standard ISO 13486-1 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 2, Braking systems and equipment. ISO 13486 consists of the following parts, under the general title Road vehicles - Hydraulic braking systems: Part 1: Double-flare pipes, tapped holes, male fittings and tube seats -Part2:Flare-to-flareconnections ii Not for Resale