ISO INTERNATIONAL STANDARD 8442-3 First edition 1997-12-15 Materials and articles in contact with foodstuffs Cutlery and table holloware Part 3: Requirements for silver-plated table and decorative holloware Materiaux et objets en contact avec les denrées alimentaires - Coutellerie et orfevrerie de table - Partie 3: Exigences relatives a I'orfevrerie de table et décorative en métal argenté ISO Reference number ISO 8442-3:1997(E) HS under I without license from IHS Not for Resale ISO 8442-3:1997(E) Foreword ISO (theInternational Organizationfor Standardization)is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through isO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhich atechnicalcommitteehasbeenestablishedhastherighttoberepresented on that committee. International organizations, governmental and non- governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 8442-3 was prepared by the European Committee for Standardization (CEN) in collaboration with ISO Technical CEN (Vienna Agreement). ISO 8442 consists of the following parts, under the general title Materials Part 1: Requirements for cutlery for the preparation of food Part 2: Requirements for stainless steel and silver-plated cutlery Part 3: Requirements for silver-plated table and decorative holloware Part 4: Requirements for gold-plated cutlery Further parts are proposed with the following titles Part 5: Specific cutting test Part 6: Lacquered lightly silver-plated table and decorative holloware @ISO1997 All rights reserved. Unless otherwise specified, no part of this publication may be reproduceo or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. nternationalOrganizationforStandardization Casepostale56.CH-1211Geneve20Switzerland Internet [email protected] X.400 C=ch; a=400net; p=iso; o=isocs; S=central Printed in Switzerland ional Organization for Standardizatior @ ISO ISO 8442-3:1997(E) Part 7: Specification for table cutlery made of precious metals and theiralloys, especially silvercutlery Part 8: Specification for silver table and decorative holloware Annexes C to K form an integral part of this part of ISO 8442. Annexes A and B are for information only. baaniaioor Sandadization ili Not for Resale