ISO INTERNATIONAL STANDARD 4463-3 Firstedition 1995-12-15 Measurement methods for building -- Setting-out and measurement - Part 3: Check-lists for the procurement of surveys and measurement services Méthodes de mesurage pour la construction - Piquetage et mesurage - Partie 3: Listes de controle pour la fourniture de leves topographiques et de prestations de mesurage X ISO Reference number ISO4463-3:1995(E) ISO 4463-3:1995(E) Contents Page 1 Scope. 1 2 Stages of procurement of a building ... 1 3 Associated measurement procedures 1 3.1 Stage 1: Acquisition of the plot or of the existing building or buildings .... 1 3.2 Stage 2: Project planning. 1 3.3 Stage 3: Prior to project construction.. 2 3.4 Stage 4: Project construction .. 3 3.5 Stage 5: Project completion .. 3 Recommended drawing scales 4 5 Accuracy of sizes from survey drawings 4 6 Documentation..... 4 Annex A Dimensioning and setting-out from the same secondary setting-out lines... 5 @ISO1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case Postale 56: CH-1211 Geneve 20. Switzerland Printed in Switzerland ii @ ISO IS0 4463-3:1995(E) Foreword IsO (the International Organization for Standardization) is a worldwide technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmentai and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (lEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. ISO/TC 59, Building construction, Subcommittee SC 4, Dimensional toler- ancesandmeasurement. This first edition of ISO 4463-3, together with ISO 4463-1 and ISO 4463-2. cancels and replaces IsO 4463:1979, which has been technically revised. Iso 4463 consists of the following parts, under the general title Measure- ment methods for building - Setting-out and measurement. Part 1: Planning and organization, measuring procedures, acceptance criteria Part 2: Measuring stations and targets Part 3: Check-lists for the procurement of surveys and measurement services Annex A of this part of ISO 4463 is for information only. ii