2586 International Standard OSI) Shell end mills with plain bore and tenon drive Metric series Fraises cylindriques 2 tailles, a alesage lisse, a entrainement par tenons - Série metrique Second edition - 1985-09-01 UDC 621.914.2 Ref. No. ISO 2586-1985 (E) ISO 2586-1985 ( Descriptors : tools, cutting tools, milling cutters, end mills, dimensions. Price based on 2 pages Copyright International Organization for Standardization tted without license from IHS Not for Resale Foreword ISo (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through Iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with IsO, also take part in the work. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the iSo Council. They are approved in accordance with ISO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 2586 was prepared by Technical Committee ISO/TC 29, Small tools. ISO 2586 was first published in 1973. This second edition canceis and repiaces the first edition: tolerances on L and I given in the table have been altered. @ International Organization for Standardization, 1985 Printed in Switzerland Copyrihtlinternational Oorganizatin for Standardization tted without license from IHS Not for Resale ISO 2586-1985 (E) INTERNATIONAL STANDARD Shell end mills with plain bore and tenon drive Metric series Scope and field of application 2 References This International Standard specifies the dimensions of shell end mills with plain bore and tenon drive intended for fitting to Iso 240, Milling cutters - Interchangeability dimensions for the ends of cutter arbors. cutter arbors or cutter mandrels - Metric series and inch series. It applies to metric series mills. It relates only to solid cutters, in steel. Iso 523, Milling cutters - Recommended range of outside The dimensional features of this type of cutter either with solid diameters. steel inserted biades or with brazed tips or with indexable in- serts will form the subject of further International Standards. ISo 2780, Milling cutters with tenon drive - Interchangeability The range of outside diameters of these cutters is taken from dimensions with cutter arbors -- Metric series. 1) ISO 523. 1) At present at the stage of draft. (Revision of IS0 2780-1973.) Copyright International Organization for Standardization Not for Resale