ISO INTERNATIONAL STANDARD 4463-1 First edition 1989-11-01 Measurement methods for building Setting-out and measurement Part 1 : Planning and organization, measuring procedures, acceptance criteria Methodes de mesurage pour la construction - Piquetage et mesurage Partie 1: Planification et organisation, procédures de mesurage Copyright Intemational Organi Reference number ISO 4463-1 : 1989 (E) ISO 4463-1 : 1989 (E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through Iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the Iso Council. They are approved in accordance with IsO procedures requiring at International Standard ISO 4463-1 was prepared by Technical Committee ISO/TC 59, Building construction. This first edition of ISO 4463-1 cancels and replaces ISO 4463 : 1979, of which it constitutes a technical revision. Users should note that all International Standards undergo revision from time to time and that any reference made herein to any other International Standard implies its latest edition, unless otherwise stated. @ISO 1989 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International OrganizationforStandardization Casepostale56·CH-1211Geneve20·Switzerland Printed in Switzerland ii No reproduction or networking permited without icense from IHS Not for Resale ISO4463-1:1989 (E) Contents Page 0 Introduction 1 Scope 2 Field of application 3References 4 Definitions Section one : General introduction 2 5General introduction. 2 Section two : Planning and organization of setting-out 4 6Acquisitionofinformation 4 Planning the setting-out 7.1 Reconnaissance 7.2 Grids 8 Setting-out drawings Functional responsibilities 10 Qualifications 11 Survey and site documentation. 12 Calculation Section three: Setting-out and measuring procedures Acceptance criteria . . 8 13Introduction 8 13.1 General 8 13.2 Instruments 8 13.3 Methods 8 13.4 Points 8 13.5 Acceptance criteria 8 ii No reproduction or networking permitted without license from IHS Not for Resale