ISO INTERNATIONAL STANDARD 519 Second edition 1992-12-01 Photography --- Hand-held cameras Flash-connector dimensions Photographie -- Appareils de prise de vues portatifs -- Dimensions des raccords de lampe a éclairs Reference number ISO519:1992(E) Not for Resale itted without license from IHS ISO 519:1992(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with isO, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an inter- national Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard isO 519 was prepared by Technical Committee ISO/TC 42, Photography. This second edition cancels and replaces the first edition 519:1974), the principal change being that the length of the flash- (ISO connector plug pin, the depth of the corresponding socket cavity and the ISO 1992 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm,without permissioninwritingfromthepublisher. International Organization for Standardization Case Postale 56· CH-1211 Geneve 20· Switzerland Printed in Switzerland Not for Resale ISO 519:1992(E) INTERNATIONALSTANDARD Photography --- Hand-held cameras - Flash-connector dimensions Scope This International Standard specifies flash-connector dimensions for hand-held cameras. 2 Dimensions The flash-connector dimensions shall be as shown in figure 1 and given in table 1. long The @ and symbols designate electrical polarity. Chamfe @01 + 一 Insulatian Insulation Socket Plug Figure 1 -- Flash-connector socket and plug efrom IHS Not for Resale