OSI International Standard 7824 Shipbuilding and marine structures - Lubrication nipples -- Cone and flat types Construction navale et structures maritimes -- Graisseurs --Types coniques et type plat First edition - 1986-12-15 7824-1986 (E) UDC 629.12-72 Ref. No. ISO 7824-1986 (E) Descriptors:shipbuilding,lubricationsystems,grease-nipples,dimensions,designation. ISO Price based on 4pages Noreproduction or networking permitted without license from IHS Not for Resale Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through Iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with iso, also take part in the work. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the Iso Council. They are approved in accordance with isO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 7824 was prepared by Technical Committee ISO/TC 8, Shipbuilding and marine structures. Users should note that all International Standards undergo revision from time to time and that any reference made herein to any other International Standard implies its latest edition, unless otherwise stated. ? International Organization for Standardization,1986 Printed in Switzerland No reproduction or networking permtted withoutlicense from IHS by IHS Not fr esale INTERNATIONAL STANDARD ISO 7824-1986 (E) Shipbuilding and marine structures - Lubrication nipples - Cone and flat types 1 Scope and field of application ISo 3799, Textile machinery and accessories - Hydraulic lubrication fittings for textile machinery. This International Standard specifies the types of hydraulic lubrication nipples for shipbuilding and marine structures, and lays down their dimensions. To facilitate the lubrication of machine parts, it is recom- Dimensions mended that the number of types and dimensions of nipples be limited in order to avoid the use of too great a number of 3.1 Cone types grease-pumps (grease-guns). Cone lubrication nipples types 1, 2 and 3, the dimensions of which are taken from Iso 3799, are suitable for general use. 2 References (See figure 1 and table 1.) ISo 261, /SO general purpose metric screw threads -- General NOTE - Cone type nipples are also commonly known as "hydraulic plan. grease nipples" Provided by IHS under license withISO or Standardizatior No reproduction or networking permited withoutlicense from IHS Not for Resale