INTERNATIONAL ISO STANDARD 8283-3 Firstedition 1992-12-01 Plastics pipes and fittings - Dimensions of sockets and spigots for discharge systems inside buildings - Part 3: Polypropylene (PP) Tubes et raccords en matieres plastiques -Dimensions des emboitures et des bouts malespourraccordement detubes et raccords dans les systemesd'évacuationaI'interieurdesbatiments- Partie3:Polypropylene (PP) Reference number ISO8283-3:1992(E) COPYRIGHT 2ooo International Organization For Standardization Information Handling Services, 2ooo ISO E929 PT*3 92 - Eobtsgh 0522069 171 ISO 8283-3:1992(E) Foreword Iso(theInternational Organization for Standardization)is a worldwide federationofnationalstandardsbodies(isOmemberbodies).Thework of preparing International Standards is normally carried out through so technical committees.Each memberbodyinterested ina subjectfor which a technical committee has been established has the right to be represented on that committee.International_organizations,govern- mental and non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. DraftInternationalStandardsadoptedbythetechnicalcommitteesare national Standard requires approval by at least 75 % of the member bodies casting a vote. InternationaiStandardIso8283-3wasprepared byTechnical Committee Iso/Tc138,Plasticspipes,fittings and valvesforthe transportoffluids, Sub-Committee.sc,1,Plastics pipes and fittings for soil, waste and drainage (including land drainage). iso8283consistsofthefoliowingparts,underthegeneral titlePlastics pipes and fittings.. Dimensions of sockets and spigots for discharge systems inside buildings: Part 1: Unplasticized poly(vinyl chloride)(PvC-U) and chlorinated poly(vinyl chloride) (PVC-C) Part2:Polyethylene(PE) Part3:Polypropylene (PP) Part4:Acrylonitrile/butadiene/styrene(ABS) Annex A forms an integral part of this part of Iso 8283. ISO 1992 or by anymeans,electronic or mechanical, including photocopying and microfilm,without permission in writing from the publisher. International Organizationfor Standardization CasePostale56·CH-1211Geneve20·Switzerland Printed in Switzerland ii COPYRIGHT 2000 International ( Organization For Standardization Information Handling Services, 2oo0 8283PT*392 0522070993 ISO8283-3:1992(E) Introduction The socket design appropriate for a particular application should be chosen according to the type of system and jointing techniques to be used. Various socket designs are specified in this part of iso 8283. They may be selected for use in accordance with the requirements of relevant national standards and codes of practice, which give information on the choice of the type of system and jointing techniques to be used. ili CoPYRIGHT 2ooo International Organization For Standardization Information Handling Services, 2oo0