8738 International Standard (Iso INTERNATIONAL ORGANIZATION FOR STANDARDIZATIONMEXKAYHAPOAHAR OPTAHM3AUWR NO CTAHAAPTW3ALWW-ORGANISATION INTERNATIONALE DE NORMALISATION Plain washers for clevis pins - Product grade A Rondellesplatespouraxesd'articulation-GradeA First edition - 1986-11-01 UDC 621.882.4 Ref. No. ISO8738-1986 (E) Descriptors : fasteners, hinge pins, washers, plain washers, specifications, dimensions, designation. Price based on 3 pages Foreword ISo (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee.International organizations,govern mental and non-governmental, in liaison with Iso, also take part in the work. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by International Standard ISO 8738 was prepared by Technical Committee ISO/TC 2, Fasteners. Users should note that all International Standards undergo revision from time to time and that any reference made herein to any other International Standard implies its latest edition, unless otherwise stated. @ International Organization for Standardization, 1986 Printed in Switzerland Not for Resale ISO 8738-1986 (E) INTERNATIONAL STANDARD Plain washers for clevis pins - Product grade A 1Scope and field of application This International Standard specifies the characteristics of plain washers for clevis pins according to ISO 2340 and ISO 2341. Plain washers in accordance with this International Standard shall be used on the cotter pin end only. 2References Iso2081,Metalliccoatings-Electroplatedcoatingsofzinconironorsteel. ISo 2340, Clevis pins without head. ISO 2341, Clevis pins with head. ISo3269, Fasteners-Acceptance inspection. Iso4520,Chromateconversioncoatingson electroplatedzincandcadmiumcoatings. IsO 4759/3, Tolerances for fasteners - Part 3 : Washers for metric bolts, screws and nuts with thread diameters from 1 up to and including 150 mm - Product grades A and C. Copyright Intermational Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale