ISO INTERNATIONAL STANDARD 8758 First edition 1992-12-01 Cinematography -- Photographic control and data records on 16 mm and 35 mm motion-picture film and prints -- Dimensions and location Cinematographie -- Piste pour enregistrement photographique des donnees et controles sur films cinematographiques 16 mm et 35 mm, et surles tirages--Dimensions etemplacement Reference number ISO 8758:1992(E) Copyright International Organization for Standardization No reproduction or networking permited without license from IHS Not for Resale ISO 8758:1992(E) Foreword iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (iso member bodies). The work of preparing International Standards is normally carried out through iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. .International organizations,govern- mental and non-governmental, in liaison with iso,also take part in the work. iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization Draft International Standards adopted by the technical committees are national Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard IsO 8758 was prepared by Technical Committee ISO/TC 36, Cinematography. Annex A of this International Standard is for information only C ISO 1992 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organizationfor Standardization Case Postale 56·CH-1211Geneve20Switzerland Printed in Switzerland Copyright Intermational Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale INTERNATIONAL STANDARD ISO8758:1992(E) Cinematography -- Photographic control and data records on 16 mm and 35 mm motion-picture film and prints - Dimensions and location Scope dicated below. Members of IEC and ISO maintain registers of currently valid International Standards. This International Standard specifies the location and dimensions of photographic control and data Iso2939:1986,Cinematography records on 16 mm motion-picture originals, inter- area and photographic sound record on 35 mm mediates and prints, 35 mm motion-picture camera motion-picture release prints -- Position and dimen negatives and 35 mm motion-picture release prints. sions It also specifies the width scanned by the control Iso 7343:1983,Cinematography --- Two-track photo- data reproducer, and the reproducer spectral sensi- graphic sound records on 35 mm motion-picture tivity prints - Positions and width dimensions. In the case of release prints, this International Stan- 3 Location and dimensions dard is restricted to those containing variable area sound records in accordance with Iso 2939 and ISO 7343. The dimensions and lateral location of the control and data records shall be as shown in figures 1 to 3 and given in tables 1 to 3. Normative references Reproducer spectral sensitivity The following standards contain provisions which, through reference in this text, constitute provisions The peak or maximum response of the combination of this International Standard. At the time of publi- of the control and data track reproducerialight cation, the editions indicated were valid. All stan- source, filter and receptor shall be at 550 dards are subject to revision, and parties to The integrated response of this combination to all agreements based on this international Standard wavelengths greater than 800 nm shall be less than are encouraged to investigate the possibility of ap- 5 % of the total integrated response measured from plying the most recent editions of the standards in- 400nmto 800nm. lotfor Resa