STD.IS0 8925-ENGL 1989 4851903 0714087 981 INTERNATIONAL ISO STANDARD 8925 First edition 1989-11-15 AMENDMENT 1 1997-05-15 Earth-moving machinery -- Diagnostic ports AMENDMENT 1 Engins de terrassement - Orifices de controle Amendement 1 This material is reproduced from iso documents under International Organization for Standardization (IsO) Copyright License number HS/lcC/1996. Not for resale. No part of these iso documents may be consent of ISO (Case postale 56, 1211 Geneva 20, Switzerland, Fax +41 22 734 10 79), IHS or the IsO Licensor's members. ISO Reference number ISO 8925:1989/Amd.1:1997(E) Copyright Intemational Organization for Standardization se with ISC Not for Resale 818 ST.108925-ENGL 1989 48519030714088 IS0 8925:1989/Amd.1:1997(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an Internationa! a vote. Amendment 1 to International Standard ISO 8925:1989 was prepared by TechnicalCommitteeIsO/TC127.Earth-movingmachinery ?ISO1997 All rights reserved. Unless otherwise specified, no part of this publication may be photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case postale 56.CH-1211 Geneve 20.Switzerland Internet [email protected] X.400 C=ch; a=400net; p=iso; o=isocs; S=central Printed in Switzerland i CopyrightIntenationarganizationfSandardization Not for Resale STD.150 8925-ENGL 1989 4851903 0714089 754 @ISO ISO 8925:1989/Amd.1:1997(E) Earth-moving machinery -- Diagnostic ports AMENDMENT 1 Page 1, 3.1 Replace subclause 3.1 with the following and delete the footnote at the bottom of page 1). The port size for measuring temperature and pressure, and to obtain fluid samples shall be M10 × 1,25. of 8 mm outside diameter shall be most preferable. Copyright International Organization for Standardization withISO No reproduction or networking permitted without license from IHS Not for Resale