ISO INTERNATIONAL STANDARD 9119 First edition 1990-12-01 Cross-country skis --- Binding mounting area Requirements and test methods Skis de fond -- Zone de montage de la fixation -- Specifications et methodes d'essai Reference number ISO 9119:1990(E) CopyrightInternational Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO9119:1990(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies).The work of preparing International Standards is normally carried out through Iso which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with iso, aiso take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an Inter- national Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard IsO 9119was prepared byTechnical Committee Iso/TC 83, Sports andrecreational equipment. This first edition cancels and replaces IsO 7264:1983, IsO 7265:1984 and ISO7793:1984. C ISO 1990 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. InternationalOrganizationforStandardization Case Postale 56·CH-1211Geneve 20·Switzeriand Printed in Switzerland for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO9119:1990(E) Introduction signer to locate reinforcing elements within this area. Standard dimen- sions also enable the binding designer to determine all interface dimensions for binding unit size, screw locations, etc. Bindings and skis manufactured in compliance with this International Standard are com- patible. ii NoreproductionornetworkingpemittedwithoutlicensefromHS Not for Resale