ISO INTERNATIONAL STANDARD 11948-1 First edition 1996-11-15 Urine-absorbing aids - Part 1: Whole-product testing Aides pour absorption d'urine- Partie 1: Essais portant sur le produit entier ISO Reference number ISO 11948-1:1996(E) No reproduction or networking permitted without license from IHS Not for Resale ISO 11948-1:1996(E) Contents Page Scope 1 2 Normative references . 3 Definitions 1 4 Principle.. 1 5 Preconditioning of test samples. 1 6 Test conditions 2 7 Reagent.. 2 8 Apparatus 2 9 Procedure 5 10 Testreport 6 Annex A Bibliography ISO1996 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form orby any means, electronic ormechanical, including protocopying and microfilm,withoutpermission inwritingfromthepublisher. InternationalOrganizationforStandardization Case postale 56 . CH-1211 Geneve 20 : Switzerland Internet [email protected] X.400 C=ch; a=400net; p=iso; o=isocs; s=central Printed in Switzerland Copyright! Oy IH No reproduction or networking permited without license from IHS Not for Resale @ISO ISO 11948-1:1996(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non- governmental, in liaison with iso, also take part in the work. iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard isO 11948-1 was prepared by Technical Committee ISO/TC 173, Technical systems and aids for disabled or handicapped persons, Subcommittee Sc 3, Aids for ostomy and incontinence. Iso 11948 consists of the following parts, under the general title Urine- absorbing aids: Part 1: Whole-product testing. Part 2: Determination of short-time liquid release (leakage) under conditions of light incontinence and low pressure Annex A of ISO 11948 is for information only. ili lo reproduction or networking permitted withou Not for Resale