ISO INTERNATIONAL STANDARD 10630 First edition 1994-08-01 Industrial plate screens -- Specifications and test methods Toles perforées pour tamisage industriel Exigences techniques et methodes d'essai ISO Reference number ISO 10630:1994(E) No reproduction or networking permitted without lic ense from IHS Not for Resale IS0 10630:1994(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. circulated to the member bodies for voting. Publication as an International a vote. International Standard IS0 10630 was prepared by Technical Committee ISO/TC24， Sieves, sieving and other sizing methods, Subcommittee SC 7, Industrial plate screens. ISO1994 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. International Organization for Standardization Case Postale 56 · CH-1211 Geneve 20 · Switzerland Printed in Switzerland ii Copyright Intemational Organization for Standardization No reproduction or networking permited without license from IHS Not for Resale ISO 10630:1994(E) INTERNATIONAL STANDARD ISO Industrial plate screens Specifications and test methods 7 Scope 3 Definitions This International Standard specifies technical re- For the purposes of this International Standard, the quirements and test methods for perforated metal following definitions apply. plate used for industrial screening purposes and sup- plied in flat or coiled form. 3.1 plate: Flat rolled material for the manufacture of perforated metal plate, 3 mm to 12,5 mm thick, the It applies to perforated plates of low carbon steel ac- edges of which are allowed to deform freely during cording to ISo 7805-1 and ISO 7805-2 with nominal rolling, supplied in flat form and generally in rec- sizes of holes from 1 mm for round holes and 4 mm tanguiar shape, but also in any other shape according for square holes up to 125 mm according to to a design sketch.1 IS0 2194, and with a maximum plate thickness of 12,5 mm. 3.2 sheet: Flat rolled material for the manufacture of perforated metal plate, less than 3 mm thick, the edges of which are allowed to deform freely during rolling, supplied in flat form and generally in rec tangular shape, but also in any other shape according 2 Normative references to a design sketch.11 The following standards contain provisions which, 3.3 coil: Flat rolled sheet for the manufacture of through reference in this text, constitute provisions perforated metal plate, the edges of which are al- of this International Standard. At the time of publi- lowed to deform freely during rolling and which im- cation, the editions indicated were valid. All standards mediately after the final rolling pass is wound into are subject to revision, and parties to agreements regular superimposed laps. based on this International Standard are encouraged to investigate the possibility of applying the most re- 3.4 perforated plate: Screening surface consisting cent editions of the standards indicated below. of a plate with uniform holes in symmetrical arrange- Members of IEC and ISO maintain registers of cur- ment. The holes may be square, slotted, circular or rently valid International Standards. of other regular geometrical shape. IsO 2194:1991,Industrial screens Woven wire 3.5 plate thickness: Thickness of the plate before cloth, perforated plate and electroformed sheet perforation. Designation and