(ISo International Standard 7736 INTE RNATIONAL ORGANIZATION FOR STANDARDIZATIONMEXAYHAPOAHAA OPTAHM3ALWA HO CTAHAAPTW3AUWMORGANISATION INTERNATIONALE DE NORMALISATION Road vehicles - Car radio for front installation Installation space including connections Vehicules routiers - Autoradio avec montage par I'avant -- Dimensions d'encombrement, y compris les connexions First edition - 1984-03-01 UDC 621.396.62:629.113 Ref.No.ISO7736-1984(E) Descriptors : road vehicles, motor vehicles, radio equipment, instaling. Copyr Pricebased on 2pages Not for Resale Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of developing fnternational Standards is carried out through Iso technical committees. Every member body interested in a subject for which a technical committee has been authorized has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with Iso, also take part in the work. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by theIso Council. International Standard ISO 7736 was developed by Technical Committee ISO/TC 22, Roadvehicles,andwascirculatedtothememberbodiesinDecember1981 It has been approved by the member bodies of the following countries : Austria France Romania Belgium Germany, F.R. South Africa, Rep. of Brazil Hungary Spain Bulgaria Italy Switzerland China Korea, Dem. P. Rep, of USSR Czechoslovakia Netherlands Egypt, Arab Rep. of Poland The member bodies of the following countries expressed disapproval of the document ontechnical grounds: Australia Japan New Zealand Sweden United Kingdom USA International Organization for Standardization, 1984 Printed in Switzerland ed by IHS under license with IS Not for Resale ISO7736-1984 (E) INTERNATIONAL STANDARD Road vehicles Car radio for front installation Installation space including connections Scope 4 Additional fixing 1 This International Standard lays down the dimensions of the in- Fixing additional to the front fixing may be provided. stallation space for a car radio and its electrical connections for front installation. Where rear fixing is necessary, it shall be in the stippled area as shown in figure 3. If a port is provided, its details shall also be It also recommends a type of rear fixing if necessary. as in figure 3. 2Field of application 5 Recommendations for installation This International Standard is applicable to the installation of a 5.1 The space shail be planned so that the car radio is easily car radio, whether or not combined with, for exampie, tape visible and within hand reach of the driver. equipment. 5.2 It is recommended that the planned installation angle 3 Dimensions of installation space shall not bemorethan 45ofromthehorizontal where the rearof the car radio slopes downward, 3.1 Figure 1 gives the dimensions for installation by front fixing. 5.3 In particular, ventilation of the space reserved for the car radio is recommended.Heating ofthe car radioduetotheprox- imity of the heating system shall be avoided. 3.2An alternative solution for lateral fixing space is shown in figure 2. 5.4All holesandaperturesshallbefreefromsharpedgesto NOTE-A combination of bothfixingtypes (3.1and3.2) can'beused. minimize the risk of injury during installation. Dimensions in millimetres 188 min. 182°8.8 uw 5 - 60 min. 20 min. 30 min. 5 ±1 Area for trim-plate 175 min.1) Figure 1 - Front fixing installation 1) This dimension represents the depth required for the appliance and its connections. opyright International Organizationfor Standardization 1 from IHS